Reading the RF signal level

Hi All,

I would like to build an application for reading the RF level on the tuner card.

I have some past experience building Enigma 2 plug-in's so the UI design etc. shouldn't be an issue.

Is there an enigma Python module I can import / use to read the RF level or use to interact with the tuner at a lower level?

I've seen the OpenPLi Satfinder Plug-In which shows an SNR readout but I cannot work out where the SNR is imported from!! - I was wondering if I could work this out I could use the same technique to get a 'raw' RF level.

Does anybody have any experience reading information like this?

Cheers,

O.