Only my edid-decode build is not working.
ERROR: edid-decode-1.0-r0 do_compile: oe_runmake failed ERROR: edid-decode-1.0-r0 do_compile: Function failed: do_compile (log file is located at /home/foxbob/et/openpli-oe-core/build/tmp/work/armv7ahf-neon-oe-linux-gnueabi/edid-decode/1.0-r0/temp/log.do_compile.12748) ERROR: Logfile of failure stored in: /home/foxbob/et/openpli-oe-core/build/tmp/work/armv7ahf-neon-oe-linux-gnueabi/edid-decode/1.0-r0/temp/log.do_compile.12748 Log data follows: | DEBUG: SITE files ['endian-little', 'bit-32', 'arm-common', 'arm-32', 'common-linux', 'common-glibc', 'arm-linux', 'arm-linux-gnueabi', 'common'] | DEBUG: Executing shell function do_compile | NOTE: make -j 5 | ERROR: oe_runmake failed | make: *** No targets specified and no makefile found. Stop. | WARNING: /home/foxbob/et/openpli-oe-core/build/tmp/work/armv7ahf-neon-oe-linux-gnueabi/edid-decode/1.0-r0/temp/run.do_compile.12748:1 exit 1 from 'exit 1' | ERROR: Function failed: do_compile (log file is located at /home/foxbob/et/openpli-oe-core/build/tmp/work/armv7ahf-neon-oe-linux-gnueabi/edid-decode/1.0-r0/temp/log.do_compile.12748)